Subject: Project Take Over Sat Oct 11, 2008 11:40 pm
This was a truck i started on over two years ago when I was sharing space in Santa Clara with Wicked Fab and DGR Fabrication...
It was sold shortly after moving to another building with DGR and is now somewhere in Texas getting built completely different then it was intended be....
kyle
Posts : 25 Join date : 2008-08-24
Subject: Re: Project Take Over Sat Oct 11, 2008 11:45 pm
The main goal with this truck was to make something that had a rediculous amount of flex and was low and extremely stable...
The front suspension was composed of toyota rear leaves and the shackle in front of the frame. This was to lower the truck down and keep the need for a long slip drive shaft at bay...
kyle
Posts : 25 Join date : 2008-08-24
Subject: Re: Project Take Over Sat Oct 11, 2008 11:50 pm
The rear suspension orignally was set up with stock toyota rears, but they were swapped out later for longer T100 springs..
It used shackles at both ends with pivots...It would have recieve 2 links(1 on top of the axle on the driver side and 1 on the bottom of the axle on the passenger side), to keep the axle from walking under the truck...
This set up would have went 90* with some tweaking....